Start a project ↗

Product knowledge

Useful decisions. Better tool projects.

Practical product, OEM/ODM and quality guidance grounded in the tools and project work shown across this site.

Electric Screwdriver Spare Parts Service Plan; XOENAEN 53-in-1 precision electric screwdriver set shown as a product configuration referenceOctober 30, 2026Electric Screwdriver Spare Parts Service PlanRead article →
038Refining 3D Printed Tool Shadow-Board Clips for Repeatable Fit with XOENAEN D-106 cordless engraving pen as an application reference
September 28, 2026 · XOENAEN 3D Print & DIY Application Team

Refining 3D Printed Tool Shadow-Board Clips for Repeatable Fit

For refine 3D printed tool shadow board clips, first identify a local ridge in the clip throat that prevents the tool from seating and protect clip thickness, throat width, retention shoulder and the tool's repeatable insertion path. Start with a small safe-edge file on transfer-marked contact; use a fine rotary point used only for deep local access after a hand trial only when access requires it. Control tool gauge, clip deflection, wall temperature, throat symmetry and repeated insertion checks. Stop when the tool begins to rattle, the clip root whitens or the throat opens beyond the marked contact. Release the part only when the named tool seats and releases by the approved hand force while the clip retains it without side play.

Read article →
039Finishing 3D Printed LED Diffuser Edges Without Light Leaks with XOENAEN H101 five-speed cordless engraving pen as an application reference
September 28, 2026 · XOENAEN 3D Print & DIY Application Team

Finishing 3D Printed LED Diffuser Edges Without Light Leaks

For finish 3D printed LED diffuser edges, first identify a support mark or seam ridge on an edge that enters a retaining channel and protect edge thickness, light-blocking overlap, visible face and locating tabs. Start with a flat-backed micro abrasive used only on the marked edge; use a clean fine rotary pad used for a small local ridge after a coupon check only when access requires it. Control material clarity, heat, edge squareness, abrasive cleanliness and light-path inspection. Stop when the edge turns cloudy, a tab rounds or light becomes visible outside the intended aperture. Release the part only when the diffuser seats evenly, its visible face remains consistent and the assembled light pattern meets the approved comparison.

Read article →
040Cleaning 3D Printed Drawer-Slide Spacer Shims for Square Setup with XOENAEN H102 five-speed cordless engraving pen as an application reference
September 28, 2026 · XOENAEN 3D Print & DIY Application Team

Cleaning 3D Printed Drawer-Slide Spacer Shims for Square Setup

For clean 3D printed drawer slide spacer shims, first identify a local brim remnant or small edge burr outside the intended datum faces and protect datum thickness, parallel faces, screw clearance and the contact area against the mounting surface. Start with a safe-edge scraper followed by a small backed abrasive; use a rotary detail abrasive used only on an external burr away from the datum plane only when access requires it. Control shim thickness, face flatness, screw-hole clearance, support and repeated gauge checks. Stop when the datum face becomes shiny over a broad area, the shim rocks or thickness changes at a measured point. Release the part only when the shim seats flat, retains the approved thickness and positions the fixture without a visible alignment shift.

Read article →

Project inquiry

Bring us the brief.

Share your product, market, quantity and customization requirements. Our project team will reply with the right next step.

Request a sample ↗WhatsApp +86 189 2743 5868